Customizing Builds with Release Profiles

In Rust, release profiles are predefined and customizable profiles with different configurations that allow a programmer to have more control over various options for compiling code. Each profile is configured independently of the others.

Cargo has two main profiles: the dev profile Cargo uses when you run cargo build and the release profile Cargo uses when you run cargo build --release. The dev profile is defined with good defaults for development, and the release profile has good defaults for release builds.

These profile names might be familiar from the output of your builds:

$ cargo build
    Finished dev [unoptimized + debuginfo] target(s) in 0.0s
$ cargo build --release
    Finished release [optimized] target(s) in 0.0s

The dev and release are these different profiles used by the compiler.

Cargo has default settings for each of the profiles that apply when you haven't explicitly added any [profile.*] sections in the project’s Cargo.toml file. By adding [profile.*] sections for any profile you want to customize, you override any subset of the default settings. For example, here are the default values for the opt-level setting for the dev and release profiles:

Filename: Cargo.toml

[profile.dev]
opt-level = 0

[profile.release]
opt-level = 3

The opt-level setting controls the number of optimizations Rust will apply to your code, with a range of 0 to 3. Applying more optimizations extends compiling time, so if you’re in development and compiling your code often, you’ll want fewer optimizations to compile faster even if the resulting code runs slower. The default opt-level for dev is therefore 0. When you’re ready to release your code, it’s best to spend more time compiling. You’ll only compile in release mode once, but you’ll run the compiled program many times, so release mode trades longer compile time for code that runs faster. That is why the default opt-level for the release profile is 3.

You can override a default setting by adding a different value for it in Cargo.toml. For example, if we want to use optimization level 1 in the development profile, we can add these two lines to our project’s Cargo.toml file:

Filename: Cargo.toml

[profile.dev]
opt-level = 1

This code overrides the default setting of 0. Now when we run cargo build, Cargo will use the defaults for the dev profile plus our customization to opt-level. Because we set opt-level to 1, Cargo will apply more optimizations than the default, but not as many as in a release build.

For the full list of configuration options and defaults for each profile, see Cargo’s documentation.